POWER PLASMA 2025/M weigh just 9.4 kg including the torch, and requires single-phase power supply; it works with compressed air provided at a pressure of 3.5 bar, with an air flow of just 55 l/min (and may thus be powered by a 25-l compressor).
Pilot arc “on air” operating mode, which makes it possible to work even on painted or coated metals.
Equipped with a 4 m new CP41C plasma cutting torch, with “on air” ignition without high frequency.
High electromagnetic compatibility, per IEC 60974-10, allowing the power source to be used in the vicinity of electronic equipment (such as computers, PLC, etc.).
Explosion-proof protection of the air reducer unit.
The compliance with EN 61000-3-12 brings substantial energy saving and a wide supply voltage tolerance (+15% / -20%).
The power source can also be powered by motor-driven generators of adequate